3"(76mm), 4"(101mm), & 6"(168mm)
Quick Assembly Brackets Installation Instructions

< Back to Previous Page

Installation Guidelines
1. Transair pipe and hoses: Transair pipe should be protected from mechanical impact, particularly if exposed to collision with fork-lift trucks or when sited in an environment with moving overhead loads. Similarly, rotation of the pipe and pipe supports should be avoided. Transair pipe must not be welded.

2. Expansion and contraction: Expansion and contraction of the system should be calculated prior to installation. The system designer and installer should calculate the elongation or retraction of each Transair line according to the recommendations in this installation guide.

3. Situation to avoid: Installation within a solid mass (concrete, foam, etc.), the hanging of any external equipment to Transair pipe, the use of Transair for grounding or as a support for electrical equipment, and exposure to chemicals that are incompatible.

4. When assembling Transair connectors, do not interchange the nuts with different Transair bodies due to our calibration process.

Quick Assembly Brackets

Click Here for the Tools Page
drilling tool Drilling tool for aluminum pipe
ref. EW09 00 30 (3" - 4") or
EW09 00 51 / EW09 00 64 (6")
deburring tool Deburring tool for aluminum pipe
ref. 6698 04 02
drill Drill

1. Drill the aluminum pipe at the desired position using drilling tool ref. EW09 00 30 (3" - 4") or EW09 00 51 / EW09 00 64 (6")
2. Carefully deburr the pipe
3. Position bracket ref. RR63 and fully tighten the two screws
4. Screw on male adapter

Back to Main Training Page
  Email this Page 

Also Available from mdi

Powerex Oil-less
Air Compressors

Finite Filters
Hose Reels

Coxreels Hose Reels
Condensate Drains

Coxreels Hose Reels
TransairAluminumPipe.com is owned and operated by mdi, Manufacturers Distributor, Inc. mdi is an Authorized Parker Transair Piping System Distributor. Click Here to view the mdi Line Sheet.